Cookers, ovens and hobs
Connected to their own circuit through a cooker switch, with cable sized for the load. If the kitchen has no cooker circuit, we run one from the DB board.
A ceiling fan has to hold its own weight while spinning for years, and a cooker draws more current than any ordinary socket should carry. We hang, wire and test fans and household appliances in Doha so they run safely from the first day.
We install and connect
The fixing matters more than the fan. A ceiling fan must hang from a hook or bracket anchored into the concrete slab. Gypsum board and thin ceiling panels cannot carry a moving load, so in a room with a false ceiling the support has to pass through to the slab above.
Height comes next. The blades should be at least 2.1 metres above the floor and clear of walls, wardrobes and hanging lights. For a low ceiling we fit a short rod or a flush-mount fan.
Last is control. The fan needs its own switch and a regulator matched to the motor, or a remote receiver wired inside the canopy. A fan with a light kit needs one more wire from the switch if you want to control the light separately.
Most fan faults come down to a small part. These are the ones we are called for most.
An appliance is only as safe as the circuit it is connected to.
Connected to their own circuit through a cooker switch, with cable sized for the load. If the kitchen has no cooker circuit, we run one from the DB board.
The socket position and the earth connection are checked, so the machine does not trip the ELCB the first time it heats.
Bathroom and kitchen fans fitted and wired to the light switch or to a switch of their own.
Wired and wireless doorbells, video doorbells, and electric door locks with their power supply.
Five minutes with the rating plate can save a return trip to the shop.
Fan or appliance still in its box?Tell us what it is and where it is going. We will bring the right fixings.
New appliances often show up the limits of an old installation. If the kitchen needs more power points, see extra sockets. Hanging new light fittings at the same time saves a second visit.
Yes. The fan is not fixed to the false ceiling itself. A rod or bracket is anchored to the concrete slab above and passes through a small opening, which the canopy then covers.
The common causes are loose blade screws, blades at slightly different angles, or a set of blades that is out of balance. All three can be corrected without replacing the fan.
Yes. We assemble it, hang it, connect it, fit the regulator or remote receiver, and balance the blades before we leave.
An electric cooker or a built-in oven does. It draws far more than a socket circuit is designed for, so it is fed by its own cable from the DB board through a cooker switch.
Usually a little current is leaking to earth inside the machine, from the heating element or from damp reaching the motor or wiring. We test the machine and the socket circuit separately to see which one is at fault.
Yes. Both need a power supply and a cable route to the door. We check these at the free first visit and include them in the written quote.
For ceiling fan installation or an appliance connection in Doha, send us the model and your ceiling type. We will confirm what is needed and when we can come.
